moversmopa.blogg.se

How to configure my range extender via web GUIĢ.

RESET: With the extender powered on, use a pin to press the RESET button until all the LED flash once. Factory reset extender and set it up through Web page or Tether APP: RE will get an IP address from the router and in the router’s local network.ġ. RE LED ON indicates that the extender has connected to the router successfully. If Signal LED/Wi-Fi LED is still off, refer to What should I do if I fail to configure TP-Link Range Extender?Ĭase 2 : RE Signal Led/ Wi-Fi Led is ON, and wireless clients won’t accept the router password Factory reset RE and install it from the beginning, put in the correct Wi-Fi password during setup.Ģ. If the Wi-Fi extender says incorrect password, then the password given to the extender may be incorrect.ġ. RE LED OFF indicates that the extender has not connected to the router yet. When connecting to the Wi-Fi of extender, you should put in the router’s Wi-Fi password.Ĭase 1 : RE Signal Led/ 2.4G or 5G Wi-Fi Led are OFF, and wireless clients won’t accept the router password. Note: TP-Link range extender will use the same Wi-Fi password as the router after being configured successfully. PS4 / IOS devices fail to connect to RE's Wi-Fi network or failed to get an IP address Very long random password on RE after WPS Ĭertain devices are unable to connect to Wi-Fi extender. Wireless devices (phones, laptops, etc.) are unable to connect Wi-Fi of the extender after setup Įxtender won’t accept router Wi-Fi password after setup, saying ‘incorrect password’